HappyLiner FL-0021 VENTED - Liner 21mm suitable for Lely - Bundle 25 sets 10% Discount

HappyLiner FL-0021 VENTED Rubber Liner 21mm suitable for Lely - Bundle 25 sets 10% Discount

This liner has been specially developed for the Lely milking robot!

The advantages of the HappyLiner with vented head:

• Higher milking speed (up to 0.3);
• Less teat load;
• Calmer milking;
• Calm cows during the milking process;
• Better strip-out;
• Gradual milk discharge. Resulting in drier teats and fat acidity reducing;
• Prevents re-spray (milk backflow), reducing the chance of new infections.
• High quality rubber
• Fits in the long teat cups
• Interchangeable with the original Lely liners
• For 2500 milkings
• Improved head of the liner.
• Convex head for better attachment and less air intake.
• Bundle of 25 sets.
• 1 Set is 4 pieces
• 10% Discount
  

Step-by-step guide HappyLiner Vented

With the HappyLiner with vented head it is important that the hole at the bottom is sealed. Here is the step-by-step guide:

• Seal the hole in the stainless steel section below the cup, the stainless steel milk collection section;
• Clean and dry the hole;
• Press the silicone plug a little into the hole, +/- 5mm;
• Cut off the remaining protruding part of the plug with a sharp knife;
• Press the silicone plug into the hole with a blunt object (for example an Allen key) until it goes no further, so that the plug sits recessed in the hole of the stainless steel milk collection section.
• It is also advisable to check the pulsation settings in T4C.

The default settings are:

• 60 strokes per minute
• 43 kpa
• 65 / 35 suck/rest ratio